女人毛片免费观看,免费无码AV片在线观看软件,日韩A∨精品日韩在线观看,国产精品国产午夜免费看福利

• The reason and the solution of injection molding material shortage

  Injection molding lack of material is a common issue. Here are the causes and corresponding solutions:1. Injection Molding Process ParametersUnderinjection pressureCause: Hydraulic component failures

  2024/11/01 Injection molding material shortage

• What is a test spline injection mold

  Test Spline Injection MoldA test spline injection mold is crucial for material evaluation. Here's a concise introduction:1. Material RequirementsStrength & Hardness: High - strength and hard m

  2024/10/28 Test spline injection mold

• What are medical plastics and commonly used products?

  Medical plastics are a class of plastic materials used in the medical field, with a variety of characteristics and a wide range of applications, the following are some important knowledge about medica

  2024/10/26 Medical plastics

• Difference between PA11 and PA12

  PA11 and PA12 are both types of nylon, also known as polyamide 11 and polyamide 12.They are both thermoplastic polymers, but their raw material sources, physical properties and prices are different.Fi

  2024/10/23 PA11 and PA12

• How much does the wall thickness of plastic parts affect the product?

  The wall thickness of plastic parts has a significant influence on product quality.First, mechanical propertiesStep 1: IntensityAdequate wall thickness provides sufficient strength. If the wall thickn

  2024/10/21 The wall thickness of plastic parts

• How to improve the precision of plastic molds?

  Improving the precision of plastic molds can be started from the following aspects:First, design link1. Reasonable structural design:Ensure that the mold structure is stable and can withstand pressure

  2024/10/19 Precision of plastic molds

• Advantages and disadvantages of PA6 materials

  PA6 material is polyamide 6 or nylon 6.I. AdvantagesHigh strength: with high tensile and compressive strength, the tensile strength is higher than that of metal, and the compression strength is compar

  2024/10/17 PA6

• Why do injection parts have dents and shrinkage marks?

  The main reasons for the occurrence of depressions and sink marks in injection-molded parts are as follows:I. Material FactorsLarge Material Shrinkage RateDifferent plastic materials have different sh

  2024/10/15 Injection parts